"ADabOfOppo; Gone Plaid (Instructables Can Be Confusable)" (adabofoppo)
12/04/2014 at 15:38 • Filed to: None
0
4|
"ADabOfOppo; Gone Plaid (Instructables Can Be Confusable)" (adabofoppo)
12/04/2014 at 15:38 • Filed to: None | 0
| 4 |
I saw the !!!error: Indecipherable SUB-paragraph formatting!!! article and am curious what it would cost to have it printed. No assembly, wiring, or programming needed. Just printed.
!!! UNKNOWN CONTENT TYPE !!!
Thanks.
RamblinRover Luxury-Yacht
> ADabOfOppo; Gone Plaid (Instructables Can Be Confusable)
12/04/2014 at 15:54 |
|
Arbitrary smoke while locking chevrons or GTFAC.
Actually, I'm looking at getting 3d printing capability - mostly for my Dalek.
|
ADabOfOppo; Gone Plaid (Instructables Can Be Confusable)
> RamblinRover Luxury-Yacht
12/04/2014 at 15:57 |
|
Not sure there is enough room in the base for a smoke generator and the motor. Also, I'd rather start with a working model first, then figure our how to make it resemble the dubious physics in the movie later.
|
RamblinRover Luxury-Yacht
> ADabOfOppo; Gone Plaid (Instructables Can Be Confusable)
12/04/2014 at 15:59 |
|
Dubious physics? In my Stargate? It's more likely than you think.
KadeS
> ADabOfOppo; Gone Plaid (Instructables Can Be Confusable)
12/04/2014 at 16:53 |
|
Well, you could use shapeways.com and have them quote you... or find someone with a printer.
As far as cost goes, its probably around $5-30 depending on how much infill (hollowness) and the scale you have it at. At least if you use cheaper filament, already have a printer etc...